ProSoft Technology MVI56-DFCMR - Manual (Page 24)

MVI56-DFCMR ♦ ControlLogix Platform Installing and Configuring the Module
DF1 Interface Module with Reduced Data Block
Page 24 of 113 ProSoft Technology, Inc.
October 20, 2008
Next, define the User Defined Data Types to be used with the module. Copy
these data types from the example ladder logic if you are not using the example.
They will be defined if you are starting from the example ladder logic. The
Controller Organization window should display the User Defined Data Types
shown in the following example:
Next, define the data tag to be used to interface with the module and the ladder
logic. Open the Controller Tags Edit Tags dialog box and enter the values shown
in the following example. The MVI56-DFCMR module is defined in the example
as DFCM1. You can set the tag name to any valid tag name you desire. If you
are using the example ladder logic, this step has already been performed.
At this point, take the time to fill in the configuration values in the DFCM1 data
table and adjust array sizes. Refer to the Module Data Object section of this
document for information on configuring the module.