ProSoft Technology MVI69-DNP - Manual (Page 66)

MVI69-DNP ♦ CompactLogix or MicroLogix Platform Diagnostics and Troubleshooting
DNP 3.0 Master/Slave Communication Module
Page 66 of 129 ProSoft Technology, Inc.
November 3, 2008
4.2 LED Status Indicators
The LEDs indicate the module's operating status as follows:
Module Color Status Indication
On Data is being transferred between the module and a remote
terminal using the Configuration/Debug port. CFG Green
Off No data is being transferred on the Configuration/Debug port.
On Data is being sent/received on this port P1 Green
Off Waiting for data on this port
On Data is being sent/received on this port P2 Green
Off Waiting for data on this port
Off The MVI69-DNP is working normally. APP Amber
On The MVI69-DNP module program has recognized a
communication error on one of its DNP ports.
On The LED is on when the module is performing a write
operation on the backplane. BP Amber
Off The LED is off when the module is performing a read
operation on the backplane. Under normal operation, the LED
should blink rapidly on and off.
Off The card is not receiving any power and is not securely
plugged into the rack.
Green The module is operating normally.
OK Red/
Green
Red The program has detected an error or is being configured. If
the LED remains red for over 10 seconds, the program has
probably halted. Remove the card from the rack and re-insert
the card to restart the module's program.
Off The battery voltage is OK and functioning. BAT Red
On The battery voltage is low or battery is not present. Allow
battery to charge by keeping module plugged into rack for 24
hours. If BAT LED still does not go off, contact ProSoft
Technology, as this is not a user serviceable item.
If a configuration error is found for the client, the client configuration error word
will have a value other than zero. The configuration error word bits have the
following definitions:
Bit Description Value
0 0x0001
1 0x0002
2 0x0004
3 0x0008
4 Invalid retry count parameter 0x0010
5 The float flag parameter is not valid. 0x0020
6 The float start parameter is not valid. 0x0040
7 The float offset parameter is not valid. 0x0080
8 0x0100
9 0x0200
10 0x0400