ProSoft Technology MVI69-DNP - Manual (Page 28)

MVI69-DNP ♦ CompactLogix or MicroLogix Platform Configuring the MVI69-DNP Module
DNP 3.0 Master/Slave Communication Module
Page 28 of 129 ProSoft Technology, Inc.
November 3, 2008
[Section]/Item Value Range Description
[IED Database] Database definition for DNP master port if utilized
Binary Inputs: 0 to 7680
points
Number of binary input points contained in the IED
database to transfer to the CompactLogix processor
and obtained from the attached IED units..
Analog Inputs: 0 to 480 points Number of analog input points contained in the IED
database to transfer to the CompactLogix processor
and obtained from the attached IED units..
Counters: 0 to 240 points Number of counter points contained in the IED
database to transfer to the CompactLogix processor
and obtained from the attached IED units..
Binary Outputs: 0 to 7680
points Number of binary output points contained in the IED
database which are transferred from the CompactLogix
processor and used by the attached IED units..
Analog Outputs: 0 to 480 points Number of analog output points contained in the IED
database which are transferred from the CompactLogix
processor and used by the attached IED units..
[Section]/Item
Description
[DNP Master Slave List] Definition of the IED units to be interfaced with the
DNP master port if utilized
# This section stores information about each slave to be used by the master port.
# There must be an entry in this table for each node to be used in the command list.
# Two of the parameters in this list are coded values:
# Conf Mode ==> 0=Never, 1=Sometimes and 2=Always (select 0).
# Flags is bit coded as follows:
# Bit 0 (decimal 1) ==> Enable the slave
# Bit 1 (decimal 2) ==> Use Unsolicited messaging with this slave
# Bit 2 (decimal 4) ==> Use delay measurement with this slave
# Bit 3 (decimal 8) ==> Auto time synchronization enabled
#
# Node DL Conf Conf Conf App Rsp
# Address Mode Timeout Retry Timeout Flags
START
END
[Section]/Item
Description
[DNP Master Commands] Definition of the commands to be issued to the IED
units by the DNP master port.
# This section contains the list of commands to process on the master port.
# Node addresses present in the command list must have an entry in the
# [DNP Slave List]. Commands with nodes not present in the list will not be
# executed.
# 1 2 3 4 5 6 7 8 9 10
#Flags/ Node Data Data Cmd Device Point DNP DB IED DB Poll
#Enable Address Object Variation Func Address Count Address Address Interval
START
END