PLANET WNAP-1120 - Manual (Page 14)

Associated Clients You may press “Show Active Clients” button to check the connected client
information. After the button pressed, you will see the dialog box as below.
You may press “Refresh” to get the new client table or “Close” to close this dialog
box.
After configuration complete, please click “Apply” button to save the configuration. Then you will
see a screen below to prompt you the settings are saving successfully. If you press “Continue”,
you can proceed to configure other settings. However, the new configurations are not take
effect at this time. You must click “Apply”, and then the WNAP-1120 will restart with new
configuration. You may check the LED status to make sure WNAP-1120 finishes the
restart.
14