Chapter 2 hardware installation – PLANET WNAP-1120 User Manual

Page 10

Chapter 2 Hardware Installation

Before you proceed with the installation, it is necessary that you have enough information about the

WNAP-1120.

1. Locate an optimum location for the WNAP-1120. The best place for your WNAP-1120 is

usually at the center of your wireless network, with line of sight to all of your mobile stations.

2. Assemble the antenna to WNAP-1120. Try to place them to a position that can best cover your

wireless network. The antenna’s position will enhance the receiving sensitivity.

3. Connect RJ-45 cable to WNAP-1120. Connect this WNAP-1120 to your LAN switch/hub or a

single PC.

4. Plug in power adapter and connect to power source. After power on, WNAP-1120 will start to

work.

Note:

ONLY use the power adapter supplied with the WNAP-1120. Otherwise, the product may be

damaged. If you want to reset your WNAP-1120 to default settings, press the Reset button

15 seconds. Then release the button and wait for 10 seconds for rebooting.