3 wall mount plate mounting – PLANET IGS-10020HPT User Manual

Page 44

User’s Manual of IGS-10020HPT

2.2.3 Wall Mount Plate Mounting

To install the Industrial Managed Switch on the wall. Please follow the instructions below.

As following all DIN-Rail installation steps we use an example device to show how we install

DIN-Rail kit, procedure of the IGS-10020HPT is same as the example device.

Step 1:

Remove the DIN-Rail from the Industrial Managed Switch. Use the screwdriver to loose the screws and remove the

DIN-Rail.

Step 2:

Place the wall mount plate on the rear panel of the Industrial Managed Switch.

Step 3:

Use the screwdriver to screw the wall mount plate on the Industrial Managed Switch.

Step 4:

Use the hook holes at the corners of the wall mount plate to hang the Industrial Managed Switch on the wall.

Step 5:

To remove the wall mount plate, reverse steps above.