PLANET IGS-10020HPT User Manual
Page 273
User’s Manual of IGS-10020HPT
the same server, send to a
different server, or give up. A
retry to the same server is
counted as a retransmit as
well as a timeout. A send to a
different server is counted as a
Request as well as a timeout.
This section contains information about the state of the server and the latest round-trip
time.
Name
RFC4670 Name
Description
IP Address
-
IP address and UDP port for the accounting
server in question.
State
-
Shows the state of the server. It takes one of
the following values:
Disabled
: The selected server is disabled.
Not Ready
: The server is enabled, but IP
communication is not yet up and running.
Ready
: The server is enabled, IP
communication is up and running, and the
RADIUS module is ready to accept accounting
attempts.
Dead (X seconds left)
: Accounting attempts
were made to this server, but it did not reply
within the configured timeout. The server has
temporarily been disabled, but will get
re-enabled when the dead-time expires. The
number of seconds left before this occurs is
displayed in parentheses. This state is only
reachable when more than one server is
enabled.
Other Info
Round-Trip
Time
radiusAccClientExtRo
undTripTime
The time interval (measured in milliseconds)
between the most recent Response and the
Request that matched it from the RADIUS
accounting server. The granularity of this
measurement is 100 ms. A value of 0 ms
indicates that there hasn't been round-trip
communication with the server yet.
273