PLANET VC-810S - Manual (Page 8)

User’s Manual of VC-810S / VC-810S48
8
Management
WEB-based management
SNMP v1, v2c interface monitor*
SNMP Trap for VDSL port link up and link down status alarm.
48VDC power input for telecom installation ( VC-810S48)
Reset Button for system reset and Reset to factory default
Firmware upgrade by TFTP file transfer protocol through Ethernet network
Port Description (Double bit column)
PLANET Smart Discovery Utility for deploy management
EMI standards comply with FCC, CE class A
*Future Released Features
1.5 Product Specification
Product
VC-810S / VC-810S48
8-Port VDSL2 + 1-Port Gigabit TP/SFP Web Smart CO Switch
Hardware Specification
8-Port VDSL2, 2-Pin screwless spring terminal block connectors
VDSL
8-Port POTS/Telephone, 2-Pin screwless spring terminal block
connectors
Interface
Ethernet 1-Port Gigabit TP/SFP Combo interface, Auto-negotiation, Auto MDI/MDI-X
VDSL2 Features
Selectable Fast and Interleaved mode
Selectable target data rate
Selectable target SNR (signal to Noise Ratio) mode
POTS voices pass through
Surge protected up to 8KV
Switch Architecture Store-and-Forward
Switch Fabric 3.6Gbps / non-blocking
Address Table 8K entries
Share Data Buffer 1.25Mbit
Maximum Frame Size 1536 Bytes packet size
Flow Control
Back pressure for Half Duplex
IEEE 802.3x Pause Frame for Full Duplex
LED
System: Power, Status
VDSL: Data Active, VDSL Link/Sync.
Gigabit Port: 1000 Link/Active, 100 Link/Active
Cables
。 VDSL2: twisted-pair telephone wires (AWG24 or better) up to 1km
。 10Base-T: 2-Pair UTP Cat.3,4,5 up to 100m (328ft)
。 100Base-TX: 2-Pair UTP Cat.5, up to 100m (328ft)
。 1000Base-T: 4-pair UTP Cat 5, up to 100m
。 1000Base-SX: 50/125 and 62.5/125 fiber-optic cable, up to 550m
。 1000Base-LX: 9/125 fiber optic cable, up to 10km 50/125 and 62.5/125
fiber-optic cable, up to 550m
Performance / Distance
(Based on AWG26 wires)
• Full VDSL2 Down Stream / Up Stream bandwidth up to:*
。
200m -> 100/55Mbps
。 400m -> 85/36Mbps
。 600m -> 60/11Mbps
。 800m -> 40/5Mbps
。 1000m -> 30/1Mbps