PLANET VC-810S - Manual (Page 20)

User’s Manual of VC-810S / VC-810S48
20
2.2.5 Connecting DC Power Supply
The VC-810S48 support -48VDC power input, connect the power cable to the VDSL2 Switch at the input terminal block.
1 The size of the two screws in the terminal block is M3.5.
2 The terminals are marked “-48V”, “FG“.
3 Loosen the two screws so you can slide the DC cable beneath it. Insert the DC cable into the connector first, and
screw it down tight.
4 Connect the power cable to the DC power supply. After power up or reset, the VC-810S48 performs a cold start
procedure.
Figure 2-13 -48VDC connector
Warning:
Before connect the DC power cable to the input terminal block of VC-810S48, ensure that the power
switch in the “OFF” position and the DC power is OFF