PLANET VC-810S - Manual (Page 36)

User’s Manual of VC-810S / VC-810S48
36
■ 10/100/1000Base-T Copper / 1000Base-SX/LX SFP Interface (Port-9)
Object Description
• Port
Indicate Port number.
• Type
Indicate the Ethernet interface type.
• Link
Indicate the Port link status: Up or Down.
• Admin
User can disable or enable this port control.
Enable –- Make the port to be in operation.
Disable – Make the port to be paused.
• Mode
Allow configuring the port speed and operation mode. Draw the menu bar to select the
mode.
• Auto- Setup Auto negotiation.
• 10 half - Force sets 10Mbps/Half-Duplex mode.
• 10 Full - Force sets 10Mbps/Full-Duplex mode.
• 100 half - Force sets 100Mbps/Half-Duplex mode.
• 100 full - Force sets 100Mbps/Full-Duplex mode.
• 1000 full - Force sets 10000Mbps/Full-Duplex mode.
• Disable - Shutdown the port manually.
• Down
Input the value of packet rate sent from the connected port to this port must enable the flow
control feature of this port for the function to work normally. The available value ranges from
1 to 99 and rate unit: 1Mbps.
• Up
Input the value of packet rate sent from this port to the connected port. The available value
ranges from 1 to 99 and rate unit: 1Mbps.
• Flow Control
Allow Enable or Disable flow control for selected port.
• Enable – 802.3x flow control is enabled on Full-Duplex mode or Backpressure is
enabled on Half-Duplex mode.
• Disable – No flow control or backpressure function on no matter Full-Duplex or
Half-Duplex mode.
• Description
Can key in the description for the port.
When set each port to run at 100M Full, 100M Half, 10M Full, and 10M Half-speed modes.
The Auto-MDIX function will disable.