PLANET VC-810S - Manual (Page 19)

User’s Manual of VC-810S / VC-810S48
19
Connecting the 2-Pair telephone wire
1 Using a wire cutter, cut off the bare wire just below the plastic insulation on all two wires.
2 Then use a wire stripper to strip off about 1cm (1/2”) of the insulation from both ends of each wire. As the Figure 2-11
appears.
3 Some trial and error may be necessary to ensure the insulation is cut and not the wire when it is placed in the notch of
the cutting blades.
4 This will give you a clean piece of wire for the new connection to the Screwless Terminal Block connector. As the
Figure 2-12 appears.
5 The 'push-in' design allows tool-less insertion of twist phone wires.
6 If needed, strip the wires that are already attached to the VDSL2 ports of the VDSL2 Switch.
Figure 2-11 Use a wire stripper to stripe the telephone wire
Figure 2-12 Tools-less push-in design