PLANET VC-810S - Manual (Page 24)

User’s Manual of VC-810S / VC-810S48
24
4. CONFIGURATION
The VDSL2 Switch provide Web interface for Switch smart function configuration and make the VDSL2 Switch operate
more effectively - They can be configured through the Web Browser. A network administrator can manage and monitor the
VDSL2 Switch from the local LAN. This section indicates how to configure the VDSL2 Switch to enable its smart function.
4.1 Main Menu
Main menu appears at left side of the WEB browser interface after successfully login VC-810S. To enter any of the
submenus, simply move the cursor to the main function and click. When select further options, the configurable interface
shows at right side. The screen in Figure 4-1 appears.
Figure 4-1 Web Main screen
Via the Web-Management, the administrator can setup the VDSL2 Switch by select the functions those listed in the Main
Function. As listed at the left of the main screen, the configurable smart functions are shown as below:
System – Check the hardware, software version and System MAC address. Setting the IP address,
Firmware Update and SNTP management for the VDSL2 Switch.
Port Management - Setup per VDSL2 port mode, Rate Limit, SNR margin Port description.
VLANs – Configure VLAN Member / Port Configuration.
Quality of Service – Mapping the packet level to classify the packets priority.
Multicast – Enables or disables IGMP Snooping on the device to filter the multicast stream.
Address Learning Table – Configure MAC address table aging, aging time mode and 802.1d BPDU packet filter.
Port Mirroring - Dedicated port monitoring for incoming packets.
Link Aggregation – Configure link aggregation groups. Up to 4 VDSL2 ports per link trunk group.
Statistics - Display transmit, receive and CRC packets statistics of each port on the VDSL2 Switch.
Storm Control - Enable Storm Control function to reduce broadcast packets on the VDSL2 Switch.