6 factory default – PLANET VC-810S User Manual
Page 31
User’s Manual of VC-810S / VC-810S48
31
4.2.6 Factory Default
The Factory Reset button can reset the VDSL2 Switch back to the factory default mode. Be aware that the entire
configuration will be reset; include the IP address of the VDSL2 Switch. Once the Factory Reset item is pressed, the
screen in
Figure 4-10
appears.
Figure 4-10 Factory Default Reset screen
After the “Factory” button be pressed and rebooted, the system will load the default IP settings as following:
。
Default IP address: 192.168.0.100
。
Subnet mask: 255.255.255.0
。
Default Gateway: 192.168.0.254
。
The other setting value is back to disable or none.
To reset the VDSL2 Switch to the Factory default setting, you can also press the hardware reset
button at the front panel about 10 seconds. After the device be rebooted. You can login the
management Web interface within the same subnet of 192.168.0.xx.
Hardware Reset button