Avago Technologies MegaRAID SAS 8204ELP - Manual (Page 68)

3-18 MegaRAID SAS RAID Controller Characteristics
Copyright © 2005-2007 by LSI Logic Corporation. All rights reserved.
3.1.8 MegaRAID SAS 84016E RAID Controller
The MegaRAID SAS 84016E PCI Express Disk Array RAID Controller
has one Intel IOP333 I/O processor and two LSI SAS1068s that control
eight internal SAS or SATA ports.
This subsection provides the board layout and connector/jumper
information for the MegaRAID SAS 84016E RAID controller.
Figure 3.7
shows the connectors and the jumpers on the controller, and Table 3.7
describes them.
Figure 3.8 Layout of the MegaRAID SAS 84016E RAID Controller
Table 3.8 SAS 84016E RAID Controller – Jumpers and
Connectors
Jumper Description Type Comments
J1 IPMI-style I
2
C
connector
3-pin
connector Provides support for enclosure
management using the SCSI
Accessed Fault-Tolerant Enclosure
(SAF-TE) protocol.
J2 Individual activity
LED header for 8
ports (8-15) 16-pin
(8x2)
header Provides an LED interface to each of
the eight SAS ports (0-7). The LED
indicates activity on a port.
J3 LED Drive Fault
Connector Interface 16-pin
(8x2)
connectors Provides an LED interface to each of
the eight SAS ports (8-15). The LED
indicates a drive fault on a port.