Avago Technologies MegaRAID SAS 8204ELP - Manual (Page 55)

MegaRAID SAS RAID Controller Family 3-5
Copyright © 2005-2007 by LSI Logic Corporation. All rights reserved.
Table 3.2 SAS 8204XLP RAID Controller and SAS 8208XLP RAID
Controller – Jumpers and Connectors
Jumper Description Type Comments
J1 Serial port (RS232)
header 4-pin
header Provides access between an
integrated UART and a local bus.
The on-board UART can be used for
diagnostics with the appropriate
firmware modification.
J2 SAS Ports Ports 0–3 The ports connect the cables from
the controller to SAS physical drives,
SATA II physical drives, or a port
multiplier.
J5 SAS Ports
Note: The SAS
8204XLP RAID
controller does
not contain this
connector.
Ports 4–7 The ports connect the cables from
the controller to SAS physical drives,
SATA II physical drives, or a port
multiplier.
J7 Individual Activity
LED header for all
eight ports 16-pin
(8x2)
header Provides an LED interface
individually to eight SAS ports. The
LED indicates activity on a specific
port.
J8 Drive Fault LED
connector interface 16-pin
(8x2)
connector Provides an LED interface
individually to eight SAS ports. The
LED indicates a drive fault on a
specific port.
J9 IPMI-style SMBus
System
Management)
/I
2
C header
3-pin
header Reserved for LSI Logic internal use.