Avago Technologies MegaRAID SAS 8204ELP - Manual (Page 56)

3-6 MegaRAID SAS RAID Controller Characteristics
Copyright © 2005-2007 by LSI Logic Corporation. All rights reserved.
3.1.3 MegaRAID SAS 8300XLP RAID Controller
The MegaRAID SAS 8300XLP PCI-X Low-Profile Disk Array RAID
Controller has one Intel 80321 Intelligent I/O processor and is a zero-
channel SAS RAID controller.
This subsection provides the board layout and connector/jumper
information for the MegaRAID SAS 8300XLP RAID controller. See
Figure 3.3 and Table 3.3 for information about the jumpers and the
connectors.
Figure 3.3 Layout of the MegaRAID SAS 8300XLP RAID Controller
Table 3.3 SAS 8300XLP RAID Controller – Jumpers and
Connectors
Jumper Description Type Comments
J1 IPMI-style SMBus
(System
Management) /I
2
C
header
4-pin
header Reserved for LSI Logic internal use.
J2 Connector for battery
backup daughtercard 40-pin
connector This connector is for an optional
daughtercard that provides battery
backup on the onboard cache
SDRAM.
J3 Universal
Asynchronus
Receiver/Transmitter
(UART) debugging 3-pin
connector Reserved for LSI Logic internal use.
J4 Mode Select 2-pin
connector Reserved for LSI Logic internal use.
J2
J1
J3
J4
J5
J6
J7
J8
J9