Avago Technologies MegaRAID SAS 8204ELP User Manual
Page 32
1-16
Overview
Copyright © 2005-2007 by LSI Logic Corporation. All rights reserved.
Step 6.
Connect the SAS cables to the hard drives in the second
system.
Step 7.
Determine the SAS target requirements.
Step 8.
Perform a safety check.
a.
Make sure that all of the cables are attached correctly.
b.
Make sure that the RAID controller is installed correctly.
c.
Close the cabinet of the host system.
Step 9.
Reconnect the power cords to the system.
Step 10. Turn on the power to the system.
The controller detects the RAID configuration from the
configuration data on the drives.
This manual is related to the following products:
- MegaRAID SAS 8204ELP (Channel) MegaRAID SAS 8204XLP MegaRAID SAS 8204XLP (Channel) MegaRAID SAS 8208ELP MegaRAID SAS 8208ELP (Channel) MegaRAID SAS 8208XLP MegaRAID SAS 8208XLP (Channel) MegaRAID SAS 8300XLP MegaRAID SAS 8308ELP MegaRAID SAS 8344ELP MegaRAID SAS 84016E MegaRAID SAS 84016E (Channel) MegaRAID SAS 8408E MegaRAID SAS 8480E MegaRAID SAS 8704ELP (Channel) MegaRAID SAS 8704EM2 MegaRAID SAS 8704EM2 (Channel) MegaRAID SAS 8708ELP (Channel) MegaRAID SAS 8708EM2 MegaRAID SAS 8708EM2 (Channel)