Avago Technologies MegaRAID SAS 8204ELP User Manual
Page 60
3-10
MegaRAID SAS RAID Controller Characteristics
Copyright © 2005-2007 by LSI Logic Corporation. All rights reserved.
J9
SAS ports
Ports 0–3
The ports connect the cables from
the RAID controller to SAS or SATA
II physical drives, or a port multiplier.
J10
SAS ports
Note: This connector
is not sup-
ported on the
SAS 8304ELP
RAID control-
ler.
Ports 4–7
The ports connect the cables from
the RAID controller to SAS or SATA
II physical drives, or a port multiplier.
J11
Battery Backup
connector (located
on the back side of
the RAID controller)
20-pin
connector
Provides interface to the remote
battery pack.
Table 3.4
SAS 8304ELP RAID Controller and SAS 8308ELP RAID
Controller – Jumpers and Connectors (Cont.)
Jumper Description
Type
Comments
This manual is related to the following products:
- MegaRAID SAS 8204ELP (Channel) MegaRAID SAS 8204XLP MegaRAID SAS 8204XLP (Channel) MegaRAID SAS 8208ELP MegaRAID SAS 8208ELP (Channel) MegaRAID SAS 8208XLP MegaRAID SAS 8208XLP (Channel) MegaRAID SAS 8300XLP MegaRAID SAS 8308ELP MegaRAID SAS 8344ELP MegaRAID SAS 84016E MegaRAID SAS 84016E (Channel) MegaRAID SAS 8408E MegaRAID SAS 8480E MegaRAID SAS 8704ELP (Channel) MegaRAID SAS 8704EM2 MegaRAID SAS 8704EM2 (Channel) MegaRAID SAS 8708ELP (Channel) MegaRAID SAS 8708EM2 MegaRAID SAS 8708EM2 (Channel)