Avago Technologies MegaRAID SAS 8204ELP - Manual (Page 41)

Detailed Installation 2-5
Copyright © 2005-2007 by LSI Logic Corporation. All rights reserved.
Figure 2.2 Example of MegaRAID SAS Board Installation in a PCI-
X Slot
Step 6. Configure and Install the SAS and/or the SATA II Devices in the
Host Computer Case
Refer to the documentation for the devices for any
preinstallation configuration requirements.
Step 7. Connect SAS and/or SATA II Devices to the RAID Controller
Use SAS cables to connect SAS devices, SATA II devices, or
both to the MegaRAID SAS RAID controller. Refer to
Section 2.4, “SAS Device Cables” for SAS cable information.
Refer to Section 2.4.1, “Connecting the SAS RAID Controller
with External Connectors to Drive Boxes and Drive Expanders,”
on page 2-10
for details on connecting the controller to physical
disks and expanders.
32-bit Slots
64-bit Slots
(3.3 V)
(3.3 V)
Edge of
System Board
Bracket Screw
Press Here
Press Here