Epson BrightLink 450Wi - Manual (Page 88)

88 Using the Projector on a Network
■ If your network does not assign addresses automatically, turn
off
DHCP and enter the projector’s IP Address , Subnet
Mask , and Gateway Address , as needed.
To enter numbers, use the arrow buttons on the remote
control to select each number on the screen, then press the
Enter button. When you’re finished entering an address in
the network menu, highlight Finish , then press the Enter
button.
10. Press Esc to return to the previous menu.
11. To prevent the IP address from appearing on the standby screen,
set the IP Address Display setting to Off .
12. When you’re done making these changes, press Esc , select
Complete and press Enter. Then select Yes and press Enter
again to save your settings.
Press Menu to exit the menu system.