Epson BrightLink 450Wi - Manual (Page 41)

Displaying and Adjusting the Image 41
2. Press the Ppower button on the projector or on the remote
control.
The projector beeps once and the Ppower light flashes green as
the projector warms up, then an image begins to appear. When
the Ppower light stops flashing and remains green, the projector
is ready for use.
3. If you are prompted to enter a password, see page 80.
Using the Direct Power On Function
The Direct Power On function enables faster setup. The projector
starts up automatically when you plug it in or turn it on with a wall
switch. You don’t have to press the Ppower button.
Follow these steps to enable Direct Power On:
1. Press the Menu button on the remote control or projector, then
select the Extended menu and press Enter .
2. Choose Operation and press Enter .
3. Choose Direct Power On and press Enter .
4. Highlight On and press Enter .
5. Press Menu to exit. The setting will take effect the next time you
plug the projector into a power outlet or turn it on with a wall
switch.
warning
Never look into the lens
when the lamp is on. This
can damage your eyes, and is
especially dangerous for
children.
note
If a power outage occurs
when Direct Power On is
enabled and the projector is
plugged in, the projector will
restart when the power is
restored.