Subaru Robin EX30 User Manual

Page 20

- 17 -

Step

Parts to remove

Remarks and procedures

Fasteners

Ignition coil

Remove the spark plug cap from the spark plug and
remove the ignition coil from the crankcase.

10 mm box spanner
M6 x 25mm : 2 pcs.

Starting pulley

Wear work gloves during operation to avoid a possible
injury by a sharp edge.
Remove the starting pulley from the fl ywheel.
Fit a box wrench or a socket wrench on the fl ywheel
nut and loosen the nut by knocking the wrench sharply
with a hammer. (See Figure STEP14-A)
NOTE:
1) Do not insert a screwdriver or other object between

the fl ywheel blades, otherwise the risk of damaging
the blades might be occured.

2) Knock the wrench with a hammer in a counter

clockwise direction.

24 mm box spanner or
socket wrench
M18 nut

Flywheel

Remove the fl ywheel from the crankshaft. Leave
the nut temporarily to prevent the fl ywheel from
dropping out. Fit the fl ywheel puller as shown in
Figure STEP15-A and remove the fl ywheel from
the crankshaft by rotating the bolt at the center in a
clockwise direction.
(Knock the center bolt with a hammer sometimes)

Flywheel puller

STEP 13

STEP 14

STEP 15

STARTING PULLEY

IGNITION COIL

FLYWHEEL

M18 NUT : 1 pc.

M6 x 25 BOLT and

WASHER : 2 pcs.

FLYWHEEL PULLER

ATTACH NUT
TEMPORARILY

STEP14-A

STEP15-A