TA Triumph-Adler CLP 4532 - Manual (Page 89)

Using the Operation Panel
2-73
5 Press .
6 Press or repeatedly until and >>Duplex appears.
7 Press [OK]. A blinking question mark (?) appears.
8 Press or to change Off to On.
9 Press [OK].
10 To exit the menu selection, press [Menu].
Staple Error Detection Setting
This setting controls whether or not message Add staples appears when the finisher units runs
out of staples during output of a stabled job.
1 Press [Menu].
2 Press or repeatedly until Others > appears.
3 Press .
4 Press or repeatedly until >Finishing Error > appears.
5 Press .
6 Press or repeatedly until and >>Staple appears.
7 Press [OK]. A blinking question mark (?) appears.
8 Press or to change Off to On.
9 Press [OK].
>> D up l ex
O ff
>> D up l ex
? O ff
>> D up l ex
? O n
On Message is displayed and printing pauses. Printing resumes automatically when staples
are replenished.
Off Message is displayed, but printing continues without stapling.
Ot h er s >
>F i ni s hi n g >
E r ro r
>> S ta p le
O ff
>> S ta p le
? O ff