TA Triumph-Adler CLP 4532 - Manual (Page 15)

Handling Paper
1-9
Thick Paper
Fan the stack of paper and align the edges before loading them in the MP tray. Some types of paper
have rough edges on the back (those are created when the paper is cut). In this case, put the paper
on a flat place and rub the edges once or twice with, for example, a ruler to smooth them. Feeding
rough edged paper may cause paper jams.
NOTE: If the paper jams even after you smooth it out,
load the paper in the MP Tray with the leading edge
raised up a few millimeters as shown in the illustration.
Colored Paper
Colored paper should satisfy the same conditions as white bond paper, Paper Specifications on
page 1-2 In addition, the pigments used in the paper must be able to withstand the heat of fusing
during the printing process (up to 200°C or 392°F).
Preprinted Paper
Preprinted paper should satisfy the same conditions as white bond paper, refer to Paper
Specifications on page 1-2. The preprinted ink must be able to withstand the heat of fusing during
the printing process, and must not be affected by silicone oil.
Do not use paper with any kind of surface treatment, such as the type of paper commonly used for
calendars.
Recycled paper
Select recycled paper that meets the same specifications as the white bond paper except for
whiteness, refer to Paper Specifications on page 1-2.
NOTE: Before purchasing recycled paper, test a sample on the machine and check that the printing
quality is satisfactory.