TA Triumph-Adler CLP 4532 - Manual (Page 83)

Using the Operation Panel
2-67
6 To set the sleep timer, press [OK]. A blinking question mark (?)
appears.
7 Press or to change On to Off.
8 Press [OK]. The sleep timer is turned off.
9 To exit the menu selection, press [Menu].
Sleep Timer Timeout Time
You can adjust the length of time the printer waits before entering Auto Sleep in the absence of
data. The default time is 15 minutes.
The printer reverts to normal operation mode when the printer receives a print job, the operation
panel is operated, or one of the exterior covers is opened.
1 Press [Menu].
2 Press or repeatedly until Others > appears.
3 Press .
4 Press or repeatedly until >Sleep Timer > appears.
5 To change the timeout time, press [OK]. A blinking cursor (_)
appears.
6 Press or to increase or decrease the value at the blinking cursor and set the desired time. The
timer can be set between 5 and 240 min, in 5-minute increments. Use and to move the cursor
right and left.
7 When the desired timeout time is displayed, press [OK].
8 To exit the menu selection, press [Menu].
Received Data Dump
You can print data received by the printer as hexadecimal code for debugging programs and files.
1 Press [Menu].
2 Press or repeatedly until Others > appears.
>> A ut o S l ee p
? O n
>> A ut o S l ee p
? O ff
Ot h er s >
>S l ee p T i me r >
01 5m i n.
>S l ee p T i me r
01 5m i n.
Ot h er s >