TA Triumph-Adler CLP 4532 - Manual (Page 38)

Using the Operation Panel
2-22
2 Press or repeatedly until e-MPS > appears.
3 Press .
4 Press or repeatedly until >e-MPS Configuration >
appears.
5 Press .
6 Press or repeatedly until >>Temp. Code JOB Size
appears.
7 To change the maximum disk space, press [OK]. A blinking
cursor (_) appears.
8 Press or to increase or decrease, respectively, the value at the blinking cursor. Use and
to move the cursor right and left.
9 When the desired size is displayed, press [OK].
10 Press [Menu]. The display returns to Ready.
Maximum Space Assigned to Permanent Code Jobs
This changes the hard disk space that holds permanent code jobs. You can change the maximum
space from 0 to 9999 (megabytes). The actual maximum size depends on the size of free hard disk
space. The default size is 1/6 of the total hard disk space, rounded off in units of 50 MB. For
example, if the total hard disk space is 10 GB, the default size is 1550 MB.
1 Press [Menu].
2 Press or and select e-MPS >.
3 Press .
4 Press or and select >e-MPS Configuration >.
5 Press .
6 Press or and select >>Perm. Code JOB Size.
e- M PS >
>e - MP S >
C o nf i gu r at io n
>> T em p . C od e J OB
S i ze 1 55 0 MB
>> T em p . C od e J OB
S i ze 1 55 0 MB
e- M PS >
>e - MP S >
C o nf i gu r at io n
>> P er m . C od e J OB
S i ze 1 55 0 MB