TA Triumph-Adler CLP 4532 - Manual (Page 73)

Using the Operation Panel
2-57
1 Press [Menu].
2 Press or repeatedly until Paper Handling > appears.
3 Press .
4 Press or repeatedly until >Duplex Mode appears.
5 To activate duplex printing, press [OK]. A blinking question mark
(?) appears.
6 Press or to display the desired binding mode. The message display toggles through the
following:
Off (default)
Short edge bind
Long edge bind
7 When the desired binding mode is displayed, press [OK]. The binding mode is set.
8 To exit the menu selection, press [Menu].
Selecting the Output Stack
The Stack Select menu on the operation panel allows you to select either the face-down tray or the
faceup tray option for the output stack.
1 Press [Menu].
2 Press or repeatedly until Paper Handling > appears.
3 Press .
4 Press or repeatedly until >Stack Select appears.
5 To change the output stack, press [OK]. A blinking question mark
(?) appears.
Pa p er Ha n dl in g >
>D u pl e x M od e
O f f
>D u pl e x M od e
?O f f
P a pe r H an d li n g >
> S ta c k Se l ec t
T op tr ay Fa c eD n
> S ta c k Se l ec t
? T op tr ay Fa c eD n