RIGOL DS1000D User Manual

Page 38

RIGOL

User’s Guide for DS1000E, DS1000D Series

2-8

Figure 2- 11 Table 2- 4 The Filter menu

Menu

Settings

Comments

Digital Filter

ON
OFF

Turn on the digital filter
Turn off the digital filter

Filter Type

Setup as LPF (Low Pass Filter)
Setup as HPF (High Pass Filter)
Setup as BPF (Band Pass Filter)
Setup as BRF (Band Reject Filter)

Upper limit

Turn ( ) knob to set high limit

Lower limit

Turn ( ) knob to set low limit

Back to higher level menu (The

followings are the same)

5. Volts/Div settings

The Volts/Div control has Coarse or Fine configuration. The Vertical Sensitivity is
2mV/div - 10V/div. Coarse: It is the default setting of Volts/Div in a 1-2-5-step
sequence from 2mV/div, 5mV/div, 10mV/div, 20mV/div……10V/div. Fine: This
setting changes the vertical scale to small steps between the coarse settings. It will
be helpful to adjust the waveform in smooth steps.

Figure 2- 12 Fine configurations

Fine adjustment

Fine adjustment data

This manual is related to the following products:

DS1000E