RIGOL DS1000D User Manual

Page 36

Text mode
Original mode

RIGOL

User’s Guide for DS1000E, DS1000D Series

2-6

3. Probe Attenuation Setting

The oscilloscope allows selecting the attenuation factor for the probe. The
attenuation factor changes the vertical scaling of the oscilloscope so that the
measurement results reflect the actual voltage levels at the probe tip.

To change (or check) the probe attenuation setting, press the CH1 or CH2 button
(according to which channel in using). Press the Probe soft button to match the
attenuation factor of the probe. This setting remains in effect until changed again.

Figure 2-8 shows an example for using a 1000:1 probe and its attenuation factor.

Figure 2- 8

Use the 1000:1 attenuation

Table 2- 3 Probe setting

Probe attenuation factors

Corresponding settings

1:1

5:1

10:1

10X

50:1

50X

100:1

100X

500:1

500X

1000:1

1000X

Probe
attenuation

Vertical volt/div.

This manual is related to the following products:

DS1000E