Retrotec FanTestic Customized Reports User Manual
Page 12
rev-2014-10-27
Page 12 of 61
©Retrotec Inc. 2011-2014
-p- means a numerical value for point number is required, points within sets
For many of the items that are headers, some are the same as used in the FanTestic UI. If the
header has been translated for the FanTestic UI, these header tokens can be put into the
generated report in translated form (instead of english). User must have the language set in the
UI, and should be using a language specific template.
Replacement Token
Units
Includ
ed?
Standard(s) /
Application
Token replaced with:
Accuracy
Yes
EN13829 variants
% accuracy of measurements entered
AirChangesRefPa
no
ATTMA
reference pressure for air changes
AirChangesRefPa
no
EN13829 variants
reference pressure for air changes
AirFlow1RefPa
no
All
Reference pressure for main air flow
measurement
AirFlow2RefPa
no
All
Reference pressure for secondary air
flow measurement, if any
AirSealingNotes
N/A
ATTMA
air sealing notes
ApplicationVersion
N/A
All
FanTestic version used
ASTMRefPa1
no
ASTM
ASTM reference pressure
AvgAirChanges-Result
no
ASTM
used in the infiltration section if
heating/cooling cost not calculated
AvgCFM75-Low
no
USACE
average permeability, lower
confidence
AvgCFM75-Result
no
USACE
average permeability result
AvgCFM75-Up
no
USACE
average permeability, upper
confidence
AvgChanges50-Low
no
ATTMA
avg ach, lower confidence
AvgChanges50-Low
no
EN13829 variants
avg ach, lower confidence
AvgChanges50-Result
no
ATTMA
avg ach, /h