Precision Digital PD6730X - Manual (Page 52)

PD6730X Vantageview Super Snooper Modbus Scanner Instruction Manual
52
Set Rate Display Decimal Point (DISP.DP)
The Rate Display Decimal Point menu sets the number of decimal points in the rate display. Press Enter
to access the Rate Display Decimal Point menu.
Decimal Display Models
Set the display decimal point location for the rate display. Pressing the Right arrow moves
the decimal point one place to the right (including no decimal point). Pressing the Up arrow
moves the decimal point one place to the left. Press Enter to confirm the number of decimal
points and continue programming.
Feet and Inches Display Models
Feet and inches display models do not have this menu. On feet and inches display models,
the rate appears on the bottom display only, with no decimal locations.
Pulse Totalizer Display Setup (TOTAL)
The Total Display Setup menu configures the pulse input totalizer. For information on setting up the pulse
input, refer to Setting Pulse Input Type (PULSE.IN) on page 58.
This menu is used to configure:
Total Display Format (Top Display, Bottom Display, or Off)
Total Units
Total Display Decimal Point
Note 1: Menu selection is not present in feet and inches display models.
Total Display Format
The total display format is selected after pressing Enter at the Total Display Setup menu (TOTAL). If the
total is set to off (OFF), then no other total parameters are configured. Otherwise, the total display will be
cycled on the display with the Modbus PVs.
On decimal display models, the total may appear on the top display (TOPDSP) or bottom display (BOTDSP).
On feet and inches display models, the total may appear only on the bottom display (BOTDSP) with no
decimal points.
Note 1
Note 1