Precision Digital PD6730X - Manual (Page 45)

PD6730X Vantageview Super Snooper Modbus Scanner Instruction Manual
45
Enter Modbus PV Units (UNITS)
Each Modbus PV may have a unique engineering unit identifier to display while scanning. To program the
Modbus PV unit, select the Units menu and press Enter.
Program the custom unit as described in Setting Alphanumeric Labels on page 24. When the label has
been programmed, press Enter to confirm the label and leave the Units parameter.
Press the Menu button to back out of a menu, or hold the Menu button to exit at any time.
Set Float Data Type Decimal Point (FLOAT.DP)
This menu is only used if the PV selected was set to a data type of Float in PV Number Configuration (PV
NUM
) on page 37. To program the Modbus PV float decimal point location, select the Float Decimal Point
menu and press Enter.
Set the decimal point location to correspond to the decimal point location of the float data. Pressing the
Right
arrow moves the decimal point one place to the right (including no decimal point). Pressing the Up
arrow moves the decimal point one place to the left. Press Enter to confirm the number of decimal; points
and continue programming.
Set Display Decimal Point (DISP.DP)
Select the display decimal point location for the scaled Modbus PV value.
Decimal Display Models
Select the display decimal point location for the scaled Modbus PV value.
To program the Modbus PV display decimal point location, select the Display Decimal Point
menu
and press Enter.
Pressing the Right arrow moves the decimal point one place to the right (including no
decimal point). Pressing the Up arrow moves the decimal point one place to the left. Press
Enter
to confirm the number of decimal; points and continue programming.
Feet and Inches Display Models
On feet and inches display models, this value is fixed, the top display PVs showing feet and
inches and the bottom display PVs showing no decimal location.