MINOURA P-500AL-5S - Manual (Page 5)

Schematic of Cradle
Left Side Arm
(Front Side)
Right Side Arm
(Back side) Cradle Cap Hook
Base Plate
Alloy Clamp
Metal Collar
(Left side only)
Pivot-Pin
Pivot-Pin Fixing Bolt
Hook Fixing Bolt
Left side Arm Angle
Fixing Bolt
Right side Arm Angle
Fixing Bolt
Arm Connecting
Bolt
Clamp
Tightening
Bolt
● Two Bike Cradles are exactly same.
● Arm on P-500AL-5S is the bent type which is different from the one found on BikeTower10. This design allows to
place the bike a little further from the Pillar to help prevent scratching.
The same cradle is sold separately under the name of "Bike Cradle 4". Use this type
for adding attachment.
Install Bike Cr adle to P-500
(Fig. U)
(Fig. T)
Pillar Joint Clamp
Upper Pillar
Lower Pillar
Pillar Joint
Joint the Pillars
The pillars on P-500AL-5S are separated, not a single piece like as
previous model.
Both pillars have same diameter, and the pillar joint fastens the pillars.
The pillar joint has already been installed on the upper pillar.
You insert it into the lower pillar, then tighten the clamps to fix.
1
At first, loosen the clamp on the lower pillar by M5 hex wrench.
2
Insert the pillar joint into the lower pillar.
3 While keeping both pillars are tightly attached, tighten the clamp firmly.
(tightening torque: 8 N.m)
!
Reguraly check if the clamp bolts are securely
tightened. If these bolts have been loosened, the
pillar could be apart and fall down.
The clamp band is pre-installed on the pillar and it's temporally tightened.
Change the clamp position to your favorite location.
Bike Cradle can be set at any height and any angle on the Pillar, but you
must set it on the front side only on P-500, not angled, when you setup in
K-style leg.
1
1
2
3
(Fig. V)
To change the clamp position, loosen 1) the clamp tightening bolt and
2) the pivot-pin fixing bolt by the supplied M5 hex wrench, then 3) slide
gently.
- 5 -
8 N.m
Tighten
!
If you apply too much torque for tightening the bolt, the clamp may
be deformed. If the clamp ends touch each other, it no longer works
and you need to replace to a new clamp for your safety.