MINOURA LiveRoll R700 - Manual (Page 7)

- 7 -
1.
2.
Preparing R700 For Use
At first, adjust the quick release properly that you
can tightely fix the Front Frame by just bending
the lever.
This step shoud be done while the frame is
retracted.
Adjust the backside nut precisely that you will feel
resistance on your palm when the lever comes in
horizontal.
Do it on both sides.
!
Do not use the lever to tighten.
Use the nut ONLY.
Make sure the belt is not on the frame (resting
on rollers) so it does not get caught when you are
extending the frame.
Pull out the Front Frame until it reaches the stopper,
and tighten the quick lever firmly.
The lever should be directed to the floor.
Hook the roller belt to the groove on rollers. Rotating
the roller can finish this work easily.
Be careful not to pinch your finger.
Confirm the roller belt is hooked properly between
the center and front rollers.
!
It's not recommended to
hook the roller belt to the
rollers BEFORE extending
the front frame.
To do so, you need to hold
R700 by pressing the rear
roller with your foot. Keep a
steady pressure with your
toe so R700 doesn't snap
back from belt tension and
possibly cause injury.
Adjust the quick
release properly
as the 1st step
Tighten
firmly
Tighten
firmly
Extend
!
Tighten the quick levers
firmly.
If you ride on R700 roughly,
the quick release may come
loose and the front frame will
be retracted, then you may
fall off forward.