MINOURA LiveRoll R700 - Manual (Page 4)

- 4 -
!
3. Next, install the rollers to the right side
frame with the same method of Step-2.
Make sure the Alloy Sleeve direction is
correct.
4. Stand the assembled R700 on flat and
level floor.
You will remove both hands so select
the ideal area to stand R700 safely.
Face the bottom side (with rubber
foot) toward you.
Roller Belt must go to the back side.
Install the Alloy Bar between the
frame with M6 bolt and spring
washer.
Both bars are exactly same. Each one
connects the frame as a reinforcement
bridge.
To make this job easy, you had set both
frames at same length in Step-1.
!
Do NOT put the Alloy Bar through the
roller belt.
The bar will impede the belt line and will
cause damage.
(from bottom)
Spring Washer
M6 Bolt
Alloy Bar
5. Lay down R700 on the floor, and tighten
all dome nuts firmly.
!
Do not try to tighten the nut at
your maximum power. It will cause
serious damage on the frame, axle
thread and alloy sleeves.
The desired tightening torque is
20 N.m.
It's much lighter than you expect.
!
Make sure all Alloy Sleeves
are correctly inserted to
the holes on the frame.
If not, the Alloy Sleeve or
frame will be broken when
tightening the nut strongly
in Step-5.