MINOURA LiveRoll R700 - Manual (Page 5)

- 5 -
How To Install Foot-Step (option)
A convenient wooden Foot-Step is available as an option.
Your position on the R700 may be higher than you expected
and reaching the floor may be difficult. If this happens you
may not be able to come off the rollers safely.
Be aware of this fact at all times you ride on rollers.
Foot-Step provides a safe area for you to touch down on
when on R700.
Installing Foot-Step on the inside is recommended to minimize any possible damage during storage or
transportation. However Foot-Step may be set up inside or outside depending on your need.
!
Foot-Step
This guide show installing the step
on inside of the left side frame.
(from bottom)
Spring Washer
M6 Bolt
Be sure that you must set the Roller Belt on the opposite side of the step
because the step disturbs the belt line.
[ To Install On Inside Of The Frame ]
Put the step over the frame in the direction that the step legs are facing inward. Attach the shorter legs onto the
frame from outside. Put the bolt and tighten the nut from inside.
[ To Install On Outside Of The Frame ]
Attach the step to the outside of the frame in the direction that the step legs are facing outward. Attach the shorter
legs onto the frame and put the bolt then tighten the nut from inside.
Nut
Required Tools: 10mm Spanner (not included) , M4 Hex Wrench
!
Dropping, bumping into things, or otherwise abusing the frame will cause damage.
Be careful during transport.