MINOURA LiveRoll R700 - Manual (Page 3)

- 3 -
How To Setup R700
!
Required Tools: 17mm Spanner (not included) , M4 Hex Wrench
1.
2.
Take out the pre-assembled frames from the box.
Please note the longer one is the rear frame and shorter one is the
front frame. Flat side is outside and the horrow side is inside.
[ Right Side Frame ]
[ Left Side Frame ]
Install the Quick Lever and nut to the
long hole on the Rear Frame. This quick
release holds the Front Frame to adjust
the length. Quick Lever must be located
on outside.
Shorten the frame to minimum size and
tighten the quick temporally.
The tightening the quick level should
not be so tight, it's OK the Front Frame
won't come out even if you have the
frame vertically.
Quick Lever
Nut for
Quick
Release
Install the roller drums to the left side
frame first.
The roller drums are exactly same and
symmetric. No desired direction nor
position.
Put the Alloy Sleeve through the roller
axle. Make sure the narrower diameter
end of the alloy sleeve must be facing
to the frame.
Insert the narrower end to the hole on
the frame correctly. Put the flat washer,
spring washer and dome nut to the
axle.
You don't need to tighten the nut firmly
yet.
Roller Belt
Silicon Ring
Rear Roller
(from bottom)
Flat Washer
Spring Washer
Dome Nut
Make sure the narrower
end must fit to the hole
correctly.
Alloy
Sleeve
What's The Purpose Of The Silicon Rings?
R700 comes with two white silicon rings.
This will work as an position adjutable indicator on the front roller that coaches you to ride as
smooth and straight as possible.
If you wish to use, install the rings to the front roller at this step. You won't be able to install it later
without disassembling R700.
If you don't wish using the rings, leave them or use tape as another flat indicator. It's your choice.
Install the Roller Belt to both center and front rollers.
Front Roller
Center Roller
Rear Frame
Front Frame