MCZ Face - Manual (Page 35)

PELLET STOVES Chapter 5
INSTALLATION AND USE MANUAL page
35
Menu structure Technical service - Rights reserved MCZ GROUP S.p.A. - Reproduction prohibited
Esc Set
< Time and date >
Esc Set
< Chrono Off >
Esc On Set
< Program 1 >
Esc On Set
< Program 2 >
Esc On Ok
< program 2 >
70°F 21.04
OFF
Mode:AUTO Menu
Temp:72°F Fan:A
Esc 7:00 Ok
< Start program 2 >
Esc 7:00 Ok
< Start program 2 >
5.2. TIMER
This operating mode allows the programming of the start-up and
shutdown of the stove in automatic mode.
Normally, the stoves have the PROGRAMMED mode
deactivated.
The basic settings in PROGRAMMED mode are:

Choice of lighting/shutdown times

Choice of programme activation day
Setting the current date and time is essential for
proper timer operation.
See paragraph 5.1. to learn how to set the current date and time.
5.2.1. TIMER activation and selection of a programme.
There are six settable timer programmes, for each of these the user
can decide lighting and shutdown times and the days of the week on
which it is active. When one or more programmes are active, the panel
alternatively displays the state of stove TIMER “n” where “n” is the
number relating to the activated timer programmes, separated by a
dash. Example: TIMER 1 (only timer 1 programme active) or TIMER 1-4
(timer 1 and 4 programming active) or TIMER 1-2-3-4-5-6 (all timer
programmes active).
EXAMPLE OF PROGRAMMING
With the stove lit or off, enter MENU, scroll to the TIMER OFF option
(or TIMER NUMBER OF THE ACTIVE TIMER/S). Prompts PROGRAMME
1 OFF, to activate it press the SET key, using the arrow key select ON
and confirm with the OK key; the screen will now show Starting time
programme and shall prompt 00.00 as a starting time, change the
starting time using the right arrow key and press OK to confirm. The
next screen prompts the shutdown time having a time 10 minutes later
than that shown for lighting: press the right arrow key to change
shutdown time and confirm with the OK key.
Next the days of the week in which to activate, or not, the timer that
has just been set: using the arrow key select ON or OFF and confirm
with OK. If no days of the week is confirmed as active (ON), the timer
programme in turn shall not be active in the status screen (see above).