MCZ Antares '03 - Manual (Page 59)

58
10-Summary of main instructions and operating rules
Fuel type: 6 mm diameter pellets, tested according to ONORM M 7135.
The stove must be installed by an authorised MCZ technician, following the instructions contained
in this booklet.
Consult local regulations and respect safety distances from flammable materials.
SELECTION OF RECIPE
This is an operation which must be performed on first installation and each time the type of pellet
is changed. If possible, purchase only one type of pellet from your dealer of choice.
Determine the recipe according to the procedures set out in para. 3.9 on page 27, and set the
stove as set out in para. 3.10 on page 29.
LIGHTING
To light the stove, press Key (5) for several seconds.
After approx. ten minutes the message appears on display (8) "Fire regulate", which indicates the
phase of stabilisation and regularisation of combustion.
When this phase is over, the stove moves to working mode, showing on display (8) the
ambient temperature and the reference power level "3", while LED (10) indicates operating
mode "MANUAL".
Use Keys (3) and (4) to regulate the thermal power of the stove and the hot air ventilation.
SHUTDOWN
To shut down the stove, press Key (5) for several seconds.
On display (8) the message "Off" will appear and from that moment the stove automatically begins
the shutdown cycle.
WARNINGS
•
When the stove is running, keep children away from it and do not touch the appliance
without suitable protection (e.g. the gloves supplied), as contact with the skin could cause
burns.
• Keep furniture and flammable materials at the proper distance.
•
DO NOT OVERHEAT THE STOVE, OR RATHER AVOID KEEPING IT AT MAXIMUM
POWER FOR MORE THAN 60-90 MINUTES.
•
Check and clean frequently the internal components, the connecting pipe and the flue (see
chapter 4.1 of this booklet). In certain conditions of use, an accumulation of ash can occur.
• Do not put anything in the hopper but wood pellets.
• Do not use your bare hands for removing pellets from the hopper.
• Do not touch the stove with wet hands, as it is in fact an electrical appliance. Always unplug
the electrical supply cable before doing any work on the stove.
• Do not open the firedoor when the stove is running.