MCZ Antares '03 - Manual (Page 34)

Use of the stove
3.15 Automatic operation with the
timer-thermostat
The timer-thermostat function is used to program the automatic lighting and shutdown of the stove
and the setting of the desired ambient temperature over the course of the week.
•
First, set the temperature of the digital thermometer (see "Moving from manual operation to
automatic").
• Next, decide on a series of heating programs on the basis of your own needs.
A heating program consists essentially of three parameters:
Lighting time
Shutdown time
Days to which the program applies / does not apply
On MCZ stoves, up to four daily programs can be set up.
Use the example given below to help you construct your own table, then move on to the
programming of the timer-thermostat.
Monday
Tuesday
Wednasday
Thursday
Friday
Saturday
Sunday
0.00 1.00 2.00 3.00 4.00 5.00 6.00 7.00 8.00 9.00 10.00 11.00 12.00 13.00 14.00 15.00 16.00 17.00 18.00 19.00 20.00 21.00 22.00 23.00 24.00
0.00 1.00 2.00 3.00 4.00 5.00 6.00 7.00 8.00 9.00 10.00 11.00 12.00 13.00 14.00 15.00 16.00 17.00 18.00 19.00 20.00 21.00 22.00 23.00 24.00
Monday
Tuesday
Wednesday
Thursday
Friday
Saturday
Sunday
0.00 1.00 2.00 3.00 4.00 5.00 6.00 7.00 8.00 9.00 10.00 11.00 12.00 13.00 14.00 15.00 16.00 17.00 18.00 19.00 20.00 21.00 22.00 23.00 24.00
0.00 1.00 2.00 3.00 4.00 5.00 6.00 7.00 8.00 9.00 10.00 11.00 12.00 13.00 14.00 15.00 16.00 17.00 18.00 19.00 20.00 21.00 22.00 23.00 24.00
3 1 2
3 1 2
3 1 2
3 1 2
3 1 2
4
4
In this example, it will be seen that on Monday to Friday, programs 1, 2 and 3 are active, whereas
on Saturday and Sunday only program 4 is active.
Program 1
:lighting 06.00; shutdown 08.00
Program 2 :lighting 11.00; shutdown 13.00
Program 3 :lighting 16.00; shutdown 21.00
Program 4 :lighting 06.00; shutdown 21.00
…. Lighting and shutdown are
performed by the stove itself
33