MCZ Antares '03 - Manual (Page 23)

Installation of steatite cladding
Always start laying the plates starting from the lower ones.
Orienting it as shown in the diagram below, insert a plate so that the 4 screws attached to it will be
located in the housings of the supports fastened to the stove.
Repeat this operation for the remaining plates and complete by resting the top on the four rubbers
(K) of the structure.
Orient the diagram as shown in
the diagram alongside.
The curved joint between the
plates is in the centreline of the
side.
The lower and upper ends are
straight. Curved joint
Straight end
Straight end
Screws
Support
Screws
Support
Steatite
plate
K
K
Installation 22