MCZ Antares '03 - Manual (Page 22)

FITTING THE CERAMIC CLADDING
After reading the previous paragraph entitled "Orientation of the ceramics", scrupulously follow the
stages described below.
Take a panel from the pack (following the fitting sequence recommended on the previous page)
and move it to the side of the stove where it is to be fitted (fig. 10 ). Locate the panel so that the
fixed retaining hooks (A) at the front of the stove engage in the rebate in the panel as indicated in
fig. 11.
At the rear of the panel, engage the moveable hooks (B) in the appropriate rebate in the panel.
Using a screwdriver, tighten the screws in the hooks, but not all the way, so as to lock the panel
(fig 12). Check that the panel is secure and aligned with the other panels, bearing in mind that
THE PANELS MUST NEVER BE RIGIDLY FIXED.
Fit the top by resting it on the 4 rubbers (K) fitted to the frame.
Installation
Fig. 10
Fig. 12
A
B
Fig. 11 Procedure
for ASTRA-
AURORA-
K
K
21