MCZ Antares '03 - Manual (Page 29)

Use of the stove
3.6 Settings to carry out before
first lighting
Set the main switch on the rear of the stove to position (1).
The display (8) on the control panel will show the alternating message OFF / CURRENT TIME.
If the time shown is not correct, it can be reset by the procedure described below.
It is worth remembering that the internal clock is only used when programming the weekly
schedule using the TIMER function (see the relevant chapter).An incorrectly-set clock therefore
does not in any way impair the operation of the stove.
3.9 SELECTING THE RECIPE
This is an evaluation criterion exclusive to MCZ which allows the user to identify
the type of pellet which is available and as a result to select the optimum settings
for the stove. This avoids excessive fuel consumption, ensures that the expected
volume of heat is available and that the appliance is protected from damage.
SELECTION OF THE RECIPE IS AN OPERATION WHICH SHOULD BE CARRIED OUT ON
FIRST INSTALLATION AND WHENEVER THE TYPE OF PELLET CHANGES
(for example if
you change supplier or become aware visually of differences in the colour or particle size)
3.8 SELECTING THE DISPLAY LANGUAGE
The remote control has Italian already set.
For English press the following keys simultaneously: 1-5
Press key 2.
To confirm and exit press in sequence 3-3-3
For German press the following keys simultaneously: 1-5
Press keys 2-2 in sequence.
To confirm and exit press in sequence 3-3-3
The remote LCD displays the language which is being selected.
3.7 SETTING THE CURRENT TIME
Press keys 2-3-3 in sequence.
Display will show UT02 and the hour. Use key 1 or 2 to
decrease/increase the hour.
To confirm the hour selected and move on to selection of the
minute, press key 3. Display will show UT03.
Use key 1 or 2 to decrease/increase the minute (increments
of 1 minute).
To confirm the minutes selected and exit from setting the
clock, returning to standby mode, press 4-4-4.
00:
08:
:00
:10
08:10
28