Epson EPL-N7000 - Manual (Page 19)

19
Note:
The RJ-45 connector cannot be connected to the phone line connection.
Overview
This section describes the general procedure on how to set up the
print server for use on a network.
1. Check the print server operation.
Check the functions and operations of the print server, such
as status lights and RJ-45 connector. See “Print Server
Operation” for details.
2. Install the necessary components on the computer.
Make sure the necessary components (such as TCP/IP,
NetBEUI, etc.) are installed on the computer, and network
settings (such as the IP address, subnet mask, etc.) of the
computer is set. See “About Installing Components on Your
Computer” for details.
3. Connect the print server to the network.
Connect the print server to the network. See “Connecting the
Print Server to the Network” for details.
4. Install EpsonNet WinAssist/MacAssist on the computer.
Install EpsonNet WinAssist or MacAssist on the computer to
configure the print server. See “Installing EpsonNet
WinAssist/MacAssist” for details.
5. Setting an IP address for the print server using EpsonNet
Win/MacAssist.