Epson EPL-N7000 - Manual (Page 35)

How to Set Up the Print Server 35
2
2
2
2
2
2
2
2
2
2
2
2
Chapter 2
How to Set Up the Print Server
This chapter explains how to set up the print server. This includes
connecting the print server to the network, installing EpsonNet
WinAssist/MacAssist, and using EpsonNet
WinAssist/MacAssist to assign an IP address to the print server.
Connecting the Print Server to the Network
Follow the instructions below to connect the print server to the
network.
1. Make sure that your printer is turned off.
2. Connect one end of the network cable to the RJ-45 connector
on the print server, and the other end to the network.
c
Caution:
❏ You must use a Category 5 shielded twisted-pair cable to
connect the print server to prevent malfunction.
❏ Do not connect or disconnect the network cable when the
printer is on.
❏ Do not connect the print server and the computer
directly. Be sure to use a HUB to connect the print server
to the network.
Note:
You can use both 10Base-T and 100Base-TX. When you print a lot
of data, we recommend you use a high-speed network of 100Base-TX
with a light network traffic.