Epson EPL-N7000 User Manual

Page 257

Tips for Administrator

259

❏ Choose Auto when getting the IP address from a DHCP

server. The IP address is automatically obtained from the
DHCP server whenever the printer is reset or turned on.

❏ Choose PING when setting the IP address using the

arp/ping command. The print server uses the IP address
set by the arp/ping command. The settings become
available when the printer is reset or turned off and then
back on.

Note:
❏ To use Auto, a DHCP server must be installed and correctly

configured on your computer. See the online help of your
operating system for detailed instructions.

❏ Choose PING only when setting the IP address using the

arp/ping command.

7. Press the Up or Down button until IP = 0.0.0.0 appears.

Press the Enter button.

8. Press the Up or Down button until the desired value appears.

Then press the Enter button to set the value.

Note:
Repeat steps 7 and 8 to set the IP address, subnet mask, and default
gateway.

9. Turn off your printer and then turn it back on. Be sure to wait

until the initialization is complete.

Print a network status sheet to confirm the new IP address.

Note:
❏ You must first set the IP address before using EpsonNet WebAssist.

❏ See the Reference Guide for more information about settings on the

printer’s control panel.