Epson 486SX - Manual (Page 38)

Continuing From an Error Message
If your computer has never been set up, you may see an error
message, such as the following:
162 - System options not set
(Run SETUP in REFERENCE DISK)
(Resume = "F1" key)
If you see an error message like this one, follow these steps:
1. Press The computer beeps and the screen displays a
message, such as the following:
Error(s) detected
l Incorrect configuration
Set default value ? ( Y / N )
The error message next to the diamond indicates the
condition causing the error. There may be more than one
error listed in the message. Here are some of the error
messages you may see:
Time is invalid
HDD and/or HDC failed initialization
Memory size is incorrect, correction made
Cacheable range is adjusted
Incorrect configuration
Checksum is incorrect
HDD is incorrect
Some errors, such as Time is invalid, do not allow you
to set a default value, so the screen does not display the
Set default value prompt. If you see one of these
errors, press the screen displays the main Setup
menu so you can enter a new setting.
2-4 Running the Setup Program