Epson 486SX - Manual (Page 128)

Installing or Removing a Drive in the External Bay
This section describes how to install or remove an Epson
diskette drive; however, you can use these instructions to
install or remove another type of storage device. See the
manual that came with it for additional installation instructions.
Installing a Drive
On each interior side of the external drive bay, there is a plastic
guide with four support grooves, as shown below. You select
the appropriate grooves for your drive depending on the size of
your drive and where you want to locate it.
third-height drive
I
half-height drive
The third-height diskette drive that comes with your computer
is installed in the grooves at the top of the bay.
Note
If you are installing a drive that does not have a
mounting frame installed on it, follow the
instructions that came with the drive to install the frame.
7-6 Installing and Removing Drives