Setting your password, 1 click the set password menu option, 2 type the old password in the field provided – Enterasys Networks ANG-1000 User Manual
Page 39: 3 type a new password in the field provided, 4 confirm the new password in the field provided, 5 click apply
Aurorean Network Gateway-1000 User’s Guide
27
Chapter 3
Configuring the ANG-1000 with Aurorean Web Config
Setting Your Password
To further ensure security for your ANG-1000, you should configure a new
password to replace the factory-installed password netadmin.
Change the Password by performing the following steps:
1
Click the Set Password menu option.
The Set Password window appears as shown in Figure 24.
Figure 24 Set Password Window
2
Type the old Password in the field provided.
3
Type a new Password in the field provided.
4
Confirm the new password in the field provided.
5
Click Apply.
Aurorean Network Gateway 1000
Set Password
Help
VPN Status
VPN Setup
VPN
Connectivity Setup
Internet Setup
Old password:
New password:
Confirm:
Apply