Enterasys Networks ANG-1000 - Manual (Page 18)

6
Aurorean Network Gateway-1000 User’s Guide
Connecting Cables Chapter 2
Installation
Connecting an ANG-1000
The ANG-1000 is typically set up in the configuration shown below.
Figure 6 Connecting the ANG-1000
To connect the ANG-1000 Ethernet port, perform the following steps:
1 Do one of the following as shown in Figure 7:
– If you are connecting to a hub, plug the blue, straight-through
Ethernet cable into the Trusted port of the ANG-1000.
– If you are connecting directly to a computer, attach one end of the
red, cross-over cable to the Trusted port and the other end to an
RJ45 connector on your computer. Skip to Step 3.
2 Plug the opposite end of the blue Ethernet cable into a wall jack,
patch panel, or hub linked to a protected network segment.
The top link LED next to the ANG-1000’s Trusted port will
immediately light if the port is connected to a 10 Mbps network after
the unit is powered up.
Aurorean Network
Trusted
connection
External
connection
or
Hub
INTERNET
Site-to-site tunnel
ANG-3000/7000
User
User
User
Cable / DSL
Modem
Gateway-1000
Site-to-site tunnel
Internet connection
Trusted connection